- English
Equipment Details
Armor can be reforged and improved with new System Chip Tuning and Circuit Amplifier effects.
Enhance Effects
Each armor piece will gain additional effects based on their enhancement level, starting from +10.
Enhancement Lv. | Effects |
---|---|
+10 | Increased Damage to Bosses +5% |
+11 | Adaptation +1% |
Reforge
- Main Article: Reforge System
System Chip Tuning
A new system exclusive to the Exascale armor. You can obtain unsealed system chips by playing the new raid dungeons.
Chips can be tuned at NPC Haivan in Camp: Steel Wall Temporary Stronghold.
- Only system chips with 0 tuning attempts can be imbued into Exascale.
- Only unsealed system chips can be tuned and imbued.
- Imbued chips can be replaced with other chips.
How to Perform Chip Tuning
When you press 'Tune', it will either succeed or fail at random.
- ED is required for each tuning attempt.
- Tuning success rates vary between 30% and 70%.
- Success rate starts at 50%.
- The fee per attempt scales with the amount of successful attempts. Base 1m ED, each success +1m ED. Fails do not increase the fee.
|
|
Sucesss Options
|
Fail Options
|
Circuit Amplifier
You can obtain 'Circuit Amplifier' through purchase or Serpentium dungeon play. You can imbue Exascale with them using a dedicated UI.
Circuit Amplifiers are varied based on:
1) Color:
If all circuit pieces are the same color, the corresponding color will be applied to the circuit.
A set effect will apply when wearing 4 same color circuit armor pieces.
Set Name | Set Effect |
---|---|
Operate (Red) | - Adaptation +2% - Party Critical Damage +10% (Cannot be overlapped) Whenever Strength or Bravery skill is used, gain 1 stack of 'Logic' for 30 seconds (can hold up to 40 stacks). When 'Logic' reaches 40 stacks, 'Derivation' is activated. - 'Logic': Attack +0.5% per stack - 'Derivation': when [Item Special Function] is used, all 'Logic' stacks are removed and changed to a 'Reset' effect for 5 seconds. - 'Reset': Hyper Active/Master Skill Damage +500%. Recovery Item Effect -50%. Cannot obtain 'Logic' stacks. |
Circulate (Blue) | - Adaptation +2% - Party Critical Damage +10% (Cannot be overlapped) Skill cooldown reset activation will alternate between 'Flow' and 'Resistance'. Every time the effect is changed, it lasts for 30 seconds or until replaced by the other effect. - 'Flow': Max MP +40, Skill Cooldown Reset Chance +10%, All Skill Damage -5% - 'Resistance': MP Usage +5%, All Skill Damage +12% |
Restore (Green) | - Adaptation +2% - Party's Magical Attack +10% (Cannot be overlapped) - Party's Physical Attack +10% (Cannot be overlapped) When the dungeon starts, gain a 'Repair' buff for 60 seconds. When 'Repair' ends, it's replaced with 'Bridge'. While 'Bridge' is active, using [Item Special Function] will change it to 'Complete' for 5 seconds. Once it ends, it will go back to 'Repair' for 60 seconds. - 'Repair': Damage Received -12% - 'Bridge': Grants a shield equal to 30% of Max HP to allies, excluding yourself, in the surrounding area once. (Shield Duration: 10 seconds) - 'Complete': Skill Cooldown of skills registered into Transcendence Skill Slots of allies, excluding yourself, is reduced to 1 second for 5 seconds. (Cooldown: 60 sec.) (Cooldown is shared among party members.) |
2) Shape:
You can combine circuit pieces by connecting them in the shape of a circuit.
Stats are divided the shape of the circuit (I/L/T).
I/L Shape
|
T Type
|
3) Part:
Top Piece, Bottom Piece, Gloves, Shoes.
4) Identification
An additional effect can be acquired when connecting circuit pieces without a break.
[How to amplify a circuit]
A dedicated UI is available at NPC Haivan in Camp: Temporary Steel Wall Base.
- Circuit Board
- Divided into top, bottom, gloves and shoes parts. Each part has a separate circuit board to amplify your own circuit.
- You can check information about the circuit by hovering over the equipped circuit.
- Activated effects
- Displays the sum of effects applied by the circuit.
- Owned circuits
- You can check which circuits you've obtained. At this time, only the equipment part you're amplifying will be displayed.
- Right-click on a circuit item to equip it, then click the area to be equipped on the circuit board.
- Undo / Apply
- Undo / Apply buttons will be available once there is a circuit piece on the circuit board that has not yet been connected.
Updates
Date | Changes | |
---|---|---|
KR | NA | |
08/01/2024 | 08/28/2024 |
|
08/14/2024 |
|